The plate slides really nice and you can do a tale drag like it is butter

I installed this after installing plates on my pint and the screws ended up going straight through the plate plastic on the pint, even with drill at 1lb torque, I did not screw this plate in very tight because of that, kept it on 1lb. So of course, first curb I took it caught the screw head and down I went. After reading the install cards again and noticing only the pint plates specify to not overtighen, i cranked the screws down on it and noticed a bit of improvement going off curbs, it makes curbs easier to do slowly but I feel like at a decent speed i would barely tap the back on the curb, but now with the extra thickness it always hits the curb pretty solidly. Also, be aware that when going down larger inclines, you will not be able to break as effectively, also found that out the hard way...

Screws could be a little longer (screws are consumable after all and available at any stocked hardware store) but otherwise exactly as I hoped. Float Plates are must have for your board!

Love the product, but the screws it comes with have a shallower head than the stock FM ones. I'm kind of a dummy, so I'm worried I'm going to round the heads and have a tough time getting them out.

Just the right amount of slide. Absolutely necessary as it’s the only way I stop. Definitely recommend