Extended Size Battery Box replacement for Onewheel XR. 2mm more inside height and 7.5mm more length! Be sure to order the matching extended Torque bumper!
1. Injection molded, transparent, tough Polycarbonate, heavy-duty box, waterproofness guaranteed by Badgerwheel
2. Extra Strong Hard Anodized aluminum lid attaches with 3 extra fasteners compared to stock XR box for a more secure fit.
3. Top Rear Rail screw now attaches directly to the box instead of the bumper.
TORquePack: no mods required
CBXR/JWXR/CBCSO: remove material shown using Dremel tool (both sides):
Use 1.5mm - 2mm spacer to support battery (IMPORTANT!!)
5 sheets of standard Letter size paper folded in half twice is about 2mm.
Suggested wire routing:
Lid Install (requires T10 and T9 Torx)
Use pliers to squeeze the hex nuts into the box.
DO NOT force the lid!
If it doesn’t fit perfectly, remove more material per the steps above.
You can ruin the plastic if you install the screws too fast because they get really hot as they form threads into the plastic.
If using power tools, install each screw only 2mm at a time before moving on to the next screw in rotation so they have a chance to stay cool. Same with removing.
Don’t forget the vent!!
2 vents are included with each box. Check your assembled box for leaks, and install a vent over the hole.
Always top notch products!
Always best customer service you'll ever deal with
Tight fit into stock rails, hope to stuff a torque batter in there soon though which will make it all worth it!
The build quality looks perfect. Thanks TFL for keeping these in stock and thanks Robert for designing so many great products!
The built quality seems really good. I bought this for my CBCSO because I didn’t like how snug it fit into the stock battery box. This was an improvement, but it was still a little tight near the wire harness corner, even after dremeling the indicated spots inside. Besides that spot, there was noticeably more space around and underneath the battery for wire routing which was nice. The stock nut and harness screwed in perfectly with zero modification needed.
The torque rear bumper doesn’t have the best fit, there’s some gaps in the rear where the footpad, bumper, and rails meet. It still totally works, just doesn’t have that flush fit and finish that some people like on their boards.
Overall I’m pleased, hopefully it holds up to some trail abuse and stays watertight.